In this video I'll fab up some holes in the XJ 4-link and frame stiffener bracket to hold the skid plate that will eventually be bolted underneath. I chose to use 3/4" bolts and nuts to hold the skid plate and I chose to weld these nuts inside the frame rails. Fabbing...
In this video we customize then weld up a 4-link front and rear kit for the XJ Cherokee Scorpion Crawler Project. A good beginner welder: http://amzn.to/2eDa8NG The plasma cutter I use: http://amzn.to/2et53Ej A decent drill press: http://amzn.to/2fq3B85 A cheap laser...
In this video we discuss the things you will need to consider when installing a rear axle truss onto your differential. This is also a good video to watch beforehand if you are considering removing your leaf spring perches. Truss:...
In this video we take a look at and install a slick USA made product from TrailTuff Nets made specifically for your XJ cherokee! Cargo Net: http://www.trailtuffnets.com Website: http://www.bleepinjeep.com FaceBook: http://www.facebook.com/BleepinJeep *This product is...
In this video we'll talk about why the stock 4wd shift selector is junk and why you need to upgrade to Novak Conversion's cable actuated 4wd shifter! I myself was quite surprised how smooth this thing shifts once installed. It also lets me lean back the transmission...
In this video we will install a TeraFlex 4:1 Low Range kit into our NP231 Transfer case for the scorpion crawler. This kit makes your crawl ratio extremely low while still keeping the 1:1 ratio for everyday highway driving. How to Install an SYE:...
This is video takes over where we left off last time with the robotic welder and making the tie-rods. Today we will talk about heim joints and high misalignment spacers. Then we'll finish up the Full Hydro steering setup for the Scorpion Crawler build. Website:...
In this video I try and get creative to make the best possible welds I can around this piece of tubing for my full hydro tie rod arms. I come up with a solution for a semi robotic welder using a mig and a custom foot pedal to (eventually) get some really nice welds....
In this video we'll continue working on the front axle by figuring out the upper 4-link mounts courtesy of TMR Customs and then we'll use the other half of their bracket to make a guard for the PSC ram. This is kind of a part 2, here is part 1:...
Every mounting situation for a Full Hydro ram is going to be different, but in this video I'll show you the basics of how to get it in the right spot and show you where I chose to put mine on this Dana44 rubicon axle with an ox locker cover and custom double shear...
Benefits include:
• Early Video Access • Members-Only Feed
• Direct Access to Me • Artwork on the Shop Wall